TANN Corp. 7000 SCFM Used Regenerative Thermal Oxidizer (RTO)

  • TANN Corp. 7000 SCFM Used Regenerative Thermal Oxidizer (RTO)
  • Yokogawa digital chart recorder
  • Allen Bradley PLC SLC 5/03 & PanelView Plus 1000 HMI
  • Allen Bradley PLC SLC 5/03 & PanelView Plus 1000 HMI and Yokogawa digital chart recorder for RTO
  • Inside electrical control panel for TANN used RTO
  • Allen Bradley PowerFlex Variable Speed Drive for TANN RTO
  • Used TANN RTO with valve-under vertical orientation and small footprint
  • Used TANN RTO with 20-inch diameter exhaust stack and fan with 60hp motor
  • Used TANN RTO has fresh air damper with electric actuator
  • Used TANN RTO with 36-foot exhaust stack on a flatbed truck for transportation

Description

Used TANN Corp. 7,000 Regenerative Thermal Oxidizer For Sale

This TANN Corporation regenerative thermal oxidizer (RTO) has a maximum capacity of 7000 SCFM and is in exceptional condition.  The unit had previously been used to treat emissions from a heatset printing press until August 2019 when it was taken offline.

Due to its valve-under vertical orientation, this RTO model has a unique design that offers a small footprint so it requires very little real estate.  Also includes a 36 foot, 20 inch diameter exhaust stack.

  • Design flow- 7,000 SCFM (up to 400 deg F);
  • 94% effective heat exchanger, random ceramic media
  • Pre-piped gas train
  • Exhaust (main) fan with 60 hp motor
  • Allen Bradley PowerFlex Variable Speed Drive
  • Combustion blower with 3.0 hp motor (direct drive)
  • Fresh air damper with electric actuator
  • Allen Bradley PLC SLC 5/03 & PanelView Plus 1000 HMI
  • Yokogawa digital chart recorder
  • Complete owner’s manual with electrical drawings

See Before & After Photos of Refurbished RTO units by Kono Kogs, or contact our team to speak with an expert.

Specifications
(approximate; Not for Design Purposes):

Weight

44,250 lbs

Approx. Footprint

22’ long, 18'-6” wide and 12' high (excl. exhaust stack)

Electrical requirements

92 Full Load Amps

Gas requirements

1750 cfh @ 2.0 – 5.0 psi. (at full flow, cold start)

Compressed air

7 CFM @ 80 PSI

* Values displayed are approximate, do not use for design.

Request a Quote

  • This field is for validation purposes and should be left unchanged.